First Layer Issues - Troubleshooting - V1 Engineering Forum
4.5 (265) · $ 17.00 · In stock
Looking for someone who has experienced this before. When I am printing parts with a large surface area/bottom layer, I keep having this issue. Smaller parts print great. It just seems when it extrudes long lines along the bed right next to each other it has issues. It’s hard to say that is a bed adhesion problem if you were to watch it closely as it went. It’s not that each line isn’t sticking to the bed, but it looks like as the next line comes back beside it tends to peel up the previous lin
Need help troubleshooting on first layer : r/prusa3d
3D print improvements - Troubleshooting - V1 Engineering Forum
3D Printing Layer Issues - Advice - V1 Engineering Forum
P1S - Bad Prints, Troubleshot A Lot Already - Troubleshooting
3D print improvements - Troubleshooting - V1 Engineering Forum
/wp-content/uploads/2020/04/IMG_9
First Layer Problems – Assembly and first prints troubleshooting
First Layer Issues : r/3Dprinting
First layer problem with PETG - Irregular results – Assembly and
First Layer problems - Inconsistency – Assembly and first prints
P1S - Bad Prints, Troubleshot A Lot Already - Troubleshooting
🔥 The definitive guide to solving 3D printing problems by Bitfab
First Layer Problems – Assembly and first prints troubleshooting
Need help troubleshooting on first layer : r/prusa3d
First Layer problems - Inconsistency – Assembly and first prints